410 LLDP Commands
Parameter Ranges
Not applicable. Command accepts keywords only.
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, the capabilities and network policy TLVs are included.
Example
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#lldp med transmit-tlv
capabilities
console(config-if-1/g1)#lldp med transmit-tlv
network-policies
lldp notification
Use the lldp notification command in Interface Configuration mode to
enable remote data change notifications. To disable notifications, use the no
form of this command.
Syntax
lldp notification
no lldp notification
Default Configuration
By default, notifications are disabled on all supported interfaces.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
