Dell PowerConnect 6224 - Spanning-Tree Port-Priority

Spanning Tree Commands 557
Default Configuration
Portfast mode is disabled by default.
Command Mode
Global Configuration mode
Usage Guidelines
There are no usage guidelines for this command.
Example
The following example enables Portfast mode on all ports.
console(config)#spanning-tree portfast default
spanning-tree port-priority
Use the spanning-tree port-priority command in Interface Configuration
mode to configure port priority. To reset the default port priority, use the no
form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
• priority — The port priority. (Range: 0–240)
Default Configuration
The default port-priority for IEEE STP is 128.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
The priority value must be a multiple of 16.