IPv6 Routing Commands 795
Autonomous Flag................................
Enabled
console#show ipv6 interface brief
Oper.
Interface Mode IPv6 Address/Length
---------- -------- ---------------------------------
vlan3 Enabled FE80::2FC:E3FF:FE90:147/128
3FF0:1236:C261::1/64
loopback 1 Enabled FE80::2FC:E3FF:FE90:145/128
3FF0:C221:1234::1/64
loopback 2 Disabled
tunnel 1 Disabled 3FFE:1234::1/64
[TENT]
show ipv6 mld groups
The show ipv6 mld groups command is used to display information about
multicast groups that MLD reported. The information is displayed only when
MLD is enabled on at least one interface. If MLD was not enabled on any
interfaces, there is no group information to be displayed.
Syntax
show ipv6 mld groups {
group-address
| vlan
vlan-id
}
•
group-address
— The group address to display.
•
vlan-id
— A valid VLAN id.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
To Next Page
Loading...
