PowerVault ML6000 Maintenance Guide 97
4 Lift the new 9U Expansion Module, and from the front of the library, place it in the desired location.
5 Fasten the module to the rack with the rack ears.
6 Secure the two modules together by tightening the two thumbscrews at the base of the front of the
module and the two thumbscrews located at the base of the back of the module. Then lower the
module’s guide pin (located at the base of the front of the module) by turning it and pushing it down.
7 Tighten all thumbscrews located at the base of the front and back of the modules.
1 Guide pin
2 Thumbscrew
To Next Page
Loading...
