Dell PowerVault ML6000 - Replacing Front Bezels of the Access Door

PowerVault ML6000 Maintenance Guide 147
6 Secure the new front bezels to the I/E station.
Align the holes with the bolts. Hold the I/E station slide assembly in place with one hand. Using your
other hand, hang the door on the bolts and push the I/E station door directly down to secure the door
on the bolts.
7 Using the screwdriver, tighten the screw (which you removed earlier) to the back of the I/E station door.
8 Replace the tape cartridges into the same locations that you removed them from.
9 Close the I/E station door.
Replacing Front Bezels of the Access Door
1 Open the module’s I/E station and access doors.
2 Remove the operator panel. For details, see Removing and Replacing the Operator Panel (LCD)
on
page 162.
3 Using the screwdriver, remove the screws located on the back of the access door. Set the screws aside.
4 Set aside the old front bezels.
Note
When you open the access door, the library becomes disabled (the robot
assembly does not function). When you later close the access door, the
library will function normally.