PowerVault ML6000 Maintenance Guide 47
12 Install module terminators in the top and bottom module terminator connectors. See Cabling the Library
on page 22 for information on installing the module terminators.
13 Power on the library.
14 Configure the library using the operator panel Setup Wizard.
15 Add the tape cartridges to the library using the I/E station.
16 If your host application inventories the location of each tape cartridge in the library, open the host
application and re-inventory to sync the logical inventory with the physical inventory of the library.
Installing a New Multi-Module Library Configuration
Use this procedure for installing a new multi-module library. A multi-module library contains a 5U Library
Control Module and one or two 9U Expansion Modules.
There are no restrictions on where the 5U Library Control Module can be installed in the library
configuration. However, the recommended placement of the control module for library configurations up to
32U is on top of all installed 9U expansion modules. The recommended placement of the control module
for 41U library configurations is on top of three 9U expansion modules and below the top expansion module.
5U Library Control
Module
9U Expansion
Module
9U Expansion
Module
9U Expansion
Module
9U Expansion
Module
ALL LIBRARIES TALLER THAN 14U MUST BE INSTALLED IN A RACK
HAVING A MAIN PROTECTIVE EARTHING (GROUNDING) TERMINAL,
AND POWER MUST BE SUPPLIED VIA AN INDUSTRIAL PLUG AND
SOCKET-OUTLET AND/OR AN APPLIANCE COUPLER COMPLYING
WITH IEC 60309 (OR AN EQUIVALENT NATIONAL STANDARD) AND
HAVING A PROTECTIVE EARTH (GROUND) CONDUCTOR WITH A
CROSS SECTIONAL AREA OF AT LEAST 1.5 MM
2
(14 AWG).
TO ENSURE PROPER AIRFLOW AND ACCESS SPACE, ALLOW 60 CM
(24 INCHES) IN THE FRONT AND BACK OF THE LIBRARY.
To Next Page
Loading...
