PowerVault ML6000 Maintenance Guide 55
Installing the 5U Library Control Module
1 Open the 5U Library Control Module’s I/E station door and access door.
2 Lift the 5U Library Control Module and place it in the desired location.
3 If stacking the 5U Library Control Module on top of another module, secure the two modules together
by tightening the two thumbscrews at the base of the front of the module and the two thumbscrews
located at the base of the back of the module. Then lower the module’s guide pin (located at the base
of the front of the module) by turning it and pushing it down.
4 Tighten all thumbscrews located at the base of the front and back of the modules.
5 Use the rack ears to fasten the 5U Library Control Module to the rack.
6 If not already installed, install the library control blade (LCB) in the 5U Library Control Module. See
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
on page 102 for
instructions on installing the LCB.
Preparing to Use the Multi-Module Library
1 Unpark the robot assembly.
a. Gently raise the robot assembly so that it no longer rests on the parking tab.
b. With your free hand, move the parking tab to the "unparked" position so that it is removed
completely from the interior of the module (Model 1 parking tab: swivel the parking tab away
from you; Model 2 parking tab: move in a clockwise direction). When replaced correctly, the
parking tab will not accidentally swivel into the path of the robot.
Support the robot assembly by holding onto the broad metal X-axis
base plate. Lifting the robot by the thin metal rod will bend the rod.
Lifting the robot by the black plastic picker body can damage the
robot.
To Next Page
Loading...
Need help?
General