PowerVault ML6000 Maintenance Guide 73
Figure 17 Library Configuration Example 2
8 If a partition references tape drives within the module you are removing or replacing, modify any
affected partition by removing the referenced drive elements from the partition.
For example, in Figure 16 on page 71, all partitions reference drives in the 9U Library Expansion
Modules. In Figure 17
on page 73, Library_c was deleted, as well as its drive references in the 9U
Library Expansion Module. Library_a and Library_b still require partition modifications to remove the
drive reference and free the 9U Library Expansion Module of all partition resource references.
9 If you are removing or replacing a 9U Library Expansion Module, set the number of I/E station slots to
six. You can reconfigure I/E station slots after the module removal or replacement is complete.
10 Power off the library.
11 Disconnect all power cords, network data cables, and module-to-module cables from each module you
will be removing.
Label all cables before you remove them so you can later reconnect them to
their proper locations.
To Next Page
Loading...
