PowerVault ML6000 Maintenance Guide 135
6 When you are ready to cable the blade, remove the necessary number of the black rubber protective
covers from the ports on the FC I/O blades.
7 Make sure that cover plates are installed over any unused bays in the expansion module.
The LEDs for the FC I/O blade are on the bottom of the blade when the
blade is correctly installed in the expansion module.
1 Latch hooks, locked
2 FC I/O blade
3 Cover plate on empty bay
4 FC I/O blade LEDs
Bays that are not populated with blades must contain a cover plate. If
the cover plate is not installed, FC I/O blade temperature errors will
occur.
To Next Page
Loading...
