Thermo Scientific appliedbiosystems SeqStudio Flex Series - Page 261

5.
Select additional injection groups as needed.
•
Tap a well to select a single injection group.
•
Press-drag to select multiple injection groups or the entire plate.
•
Tap (Select/deselect) at the top left of the plate to select or deselect all wells on the plate.
Note: All settings in the remaining steps will be assigned to all selected injection groups. If
dierent injection groups require dierent settings, repeat these steps for each injection group.
6.
T
ap the injection pane to display the Edit Injection Properties screen.
7.
In the Edit Injection P
roperties screen, specify the settings for the injection by doing either of the
following:
•
In the Injection protocol field, select a protocol.
An injection protocol contains the elements listed below. When you select an injection
protocol, these elements are automatically selected. However, you can tap any of the fields
below the Injection protocol field to select a dierent element for the plate file as described
below. Swipe up to display the rest of the screen.
•
Select individual elements in the following fields. Selecting an individual element overrides an
injection protocol selection and clears the Injection protocol field.
–
Dye set
–
Run module
–
Analysis settings
–
Size standard (fragment analysis only)
For information on creating injection protocols and other run settings, see Chapter 11, “Manage
library resources on the instrument”.
Chapter 11 Manage libr
ary resources on the instrument
Plate files library
11
SeqStudio
™
Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
261