Agilent Technologies InfiniiVision 5000 Series

Commands A-Z 6
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 551
• "*RST (Reset)" on page 111
• RUMode Commands:
• ":MTESt:RUMode" on page 603
• ":MTESt:RUMode:SOFailure" on page 604
• ":RUN" on page 156
• RX, ":TRIGger:UART:SOURce:RX" on page 496
• RXFRames, ":SBUS:UART:COUNt:RXFRames" on page 388
S • SAMPlepoint Commands:
• ":TRIGger:CAN:SAMPlepoint" on page 428
• ":TRIGger:LIN:SAMPlepoint" on page 464
• "*SAV (Save)" on page 114
• SAVE Commands:
• ":MTESt:AMASk:{SAVE | STORe}" on page 599
• ":MTESt:RMODe:FACTion:SAVE" on page 339
• ":SAVE:FILename" on page 359
• ":SAVE:IMAGe:AREA" on page 361
• ":SAVE:IMAGe:FACTors" on page 362
• ":SAVE:IMAGe:FORMat" on page 363
• ":SAVE:IMAGe:INKSaver" on page 364
• ":SAVE:IMAGe:PALette" on page 365
• ":SAVE:IMAGe[:STARt]" on page 360
• ":SAVE:MASK[:STARt]" on page 366
• ":SAVE:PWD" on page 367
• ":SAVE:SETup[:STARt]" on page 368
• ":SAVE:WAVeform:FORMat" on page 370
• ":SAVE:WAVeform:LENGth" on page 371
• ":SAVE:WAVeform:SEGMented" on page 372
• ":SAVE:WAVeform[:STARt]" on page 369
• ":SBUS:CAN:COUNt:ERRor" on page 375
• ":SBUS:CAN:COUNt:OVERload" on page 376
• ":SBUS:CAN:COUNt:RESet" on page 377
• ":SBUS:CAN:COUNt:TOTal" on page 378
• ":SBUS:CAN:COUNt:UTILization" on page 379
• ":SBUS:DISPlay" on page 380
• ":SBUS:IIC:ASIZe" on page 381