To Next Page

To Previous Page

552 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide

6 Commands A-Z

• ":SBUS:LIN:PARity" on page 382

• ":SBUS:MODE" on page 383

• ":SBUS:SPI:WIDTh" on page 384

• ":SBUS:UART:BASE" on page 385

• ":SBUS:UART:COUNt:ERRor" on page 386

• ":SBUS:UART:COUNt:RESet" on page 387

• ":SBUS:UART:COUNt:RXFRames" on page 388

• ":SBUS:UART:COUNt:TXFRames" on page 389

• ":SBUS:UART:FRAMing" on page 390

• SCALe Commands:

• ":CHANnel<n>:SCALe" on page 205

• ":FUNCtion:SCALe" on page 240

• ":MTESt:SCALe:BIND" on page 344

• ":MTESt:SCALe:X1" on page 345

• ":MTESt:SCALe:XDELta" on page 346

• ":MTESt:SCALe:Y1" on page 347

• ":MTESt:SCALe:Y2" on page 348

• ":TIMebase:SCALe" on page 406

• ":TIMebase:WINDow:SCALe" on page 410

• SCRatch, ":MEASure:SCRatch" on page 586

• SDEViation, ":MEASure:SDEViation" on page 295

• ":SERial" on page 157

• SEGMented Commands:

• ":ACQuire:SEGMented:ANALyze" on page 171

• ":ACQuire:SEGMented:COUNt" on page 172

• ":ACQuire:SEGMented:INDex" on page 173

• ":SAVE:WAVeform:SEGMented" on page 372

• ":WAVeform:SEGMented:COUNt" on page 519

• ":WAVeform:SEGMented:TTAG" on page 520

• SETup Commands:

• ":RECall:SETup[:STARt]" on page 356

• ":SAVE:SETup[:STARt]" on page 368

• ":SYSTem:SETup" on page 397

• SHOW, ":MEASure:SHOW" on page 296

• SIGMa, ":MTESt:RMODe:SIGMa" on page 341

Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

Other manuals for Agilent Technologies InfiniiVision 5000 Series