Agilent Technologies InfiniiVision 5000 Series Programmer's Guide

566 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
Discontinued
Commands
Discontinued commands are commands that were used by previous
oscilloscopes, but are not supported by the InfiniiVision 5000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
:PRINt? (see page 607):DISPlay:DATA? (see
page 211)
:TIMebase:DELay (see
page 609)
:TIMebase:POSition (see
page 403) or
:TIMebase:WINDow:POSition
(see page 408)
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
:TRIGger:CAN:ACKNowledge
(see page 610)
none
:TRIGger:CAN:SIGNal:DEFiniti
on (see page 611)
none
:TRIGger:LIN:SIGNal:DEFinitio
n (see page 612)
none
:TRIGger:TV:TVMode (see
page 613)
:TRIGger:TV:MODE (see
page 481)
Obsolete Command Current Command Equivalent Behavior Differences
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 215)
CHANnel:MATH :FUNCtion:OPERation (see
page 237)
ADD not included
CHANnel<n>:PROTect :CHANnel<n>:PROTection
(see page 203)
Previous form of this
command was used to
enable/disable 50Ω
protection. The new command
resets a tripped protect and
the query returns the status of
TRIPed or NORMal.
DISPlay:INVerse none
DISPlay:COLumn none
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none
DISPlay:POSition none

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English