Agilent Technologies InfiniiVision 5000 Series

668 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
11 More About Oscilloscope Commands
• :FACTion
• :PRINt (see page 338)
• :SAVE (see page 339)
• :STOP (see page 340)
• :SIGMa (see page 341)
• :TIME (see page 342)
• :WAVeforms (see page 343)
• :SCALe
• :BIND (see page 344)
• :X1 (see page 345)
• :XDELta (see page 346)
• :Y1 (see page 347)
• :Y2 (see page 348)
• :SOURce (see page 349)
• :TITLe (see page 350)
• :OPEE (Operation Status Enable Register) (see page 145)
• :OPERegister
• :CONDition (Operation Status Condition Register) (see page 147)
• [:EVENt] (Operation Status Event Register) (see page 149)
• :OVLenable (Overload Event Enable Register) (see page 151)
• :OVLRegister (Overload Event Register) (see page 153)
• :RECall
• :FILename (see page 352)
• :IMAGe (see page 353)
• [:STARt] (see page 353)
• :MASK (see page 354)
• [:STARt] (see page 354)
• :PWD (see page 355)
• :SETup (see page 356)
• [:STARt] (see page 356)
• :RUN (see page 156)
• :SAVE
• :FILename (see page 359)
• :IMAGe (see page 360)
• [:STARt] (see page 360)