Agilent Technologies InfiniiVision 5000 Series

More About Oscilloscope Commands 11
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide 669
• :AREA (see page 361)
• :FACTors (see page 362)
• :FORMat (see page 363)
• :IGColors (see page 364)
• :PALette (see page 365)
• :MASK (see page 366)
• [:STARt] (see page 366)
• :PWD (see page 367)
• :SETup (see page 368)
• [:STARt] (see page 368)
• :WAVeform (see page 369)
• [:STARt] (see page 369)
• :FORMat (see page 370)
• :LENGth (see page 371)
• :SEGMented (see page 372)
• :SBUS (see page 373)
• :CAN
• :COUNt
• :ERRor (see page 375)
• :OVERload (see page 376)
• :RESet (see page 377)
• :TOTal (see page 378)
• :UTILization (see page 379)
• :DISPlay (see page 380)
• :IIC
• :WIDTh (see page 384)
• :LIN
• :PARity (see page 382)
• :MODE (see page 383)
• :SPI
• :ASIZe (see page 381)
• :UART
• :BASE (see page 385)
• :COUNt
• :ERRor (see page 386)