Dell PowerConnect 6224 - Page 126

126 Command Groups
sFlow
debug ipv6 pimsm Traces PIMSMv6 packet reception and
transmission.
PE
debug isdp Traces ISDP packet reception and transmission. PE
debug lacp Traces of LACP packets received and
transmitted by the switch.
PE
debug mldsnooping Traces MLD snooping packet reception and
transmission.
PE
debug ospf Enables tracing of OSPF packets received and
transmitted by the switch.
PE
debug ospfv3 Enables tracing of OSPFv3 packets received and
transmitted by the switch.
PE
debug ping Enables tracing of ICMP echo requests and
responses.
PE
debug rip Enables tracing of RIP requests and responses. PE
debug sflow Enables sFlow debug packet trace. PE
debug spanning-tree Traces spanning tree BPDU packet reception
and transmission.
PE
show debugging Displays packet tracing configurations. PE
NOTE: *For the meaning of each Mode abbreviation, see "Mode Types" on page 60.
Command Description Mode*
sflow destination Configures sFlow collector parameters (owner
string, receiver timeout, ip address, and port).
GC
sflow polling Enables a new sflow poller instance for the data
source if rcvr_idx is valid.
GC
sflow polling (Interface
Mode)
Enable a new sflow poller instance for this data
source if rcvr_idx is valid.
IC
sflow sampling Enables a new sflow sampler instance for this
data source if rcvr_idx is valid.
GC
Command Description Mode*