System Management Commands 1345
Examples
The following example discovers the routes that packets will actually take
when traveling to the destination specified in the command.
console#traceroute 192.168.77.171
Tracing route over a maximum of 20 hops
1 192.168.21.1 30 ms 10 ms 10 ms
2***
3***
4***
5***
The following example uses the iterative process to obtain command
parameters, and displays the routes that packets actually take when traveling
to their destination.
console#traceroute
traceroute# Enter the ip-address|hostname :
192.168.77.171
traceroute# Packet size (default: 40 bytes): 30
traceroute# Max ttl value (default: 20): 10
traceroute# Number of probes to send at each level
(default 3):
traceroute# Timeout (default: 3 seconds): 6
traceroute# Source ip-address (default to select best
interface address):
traceroute# Type of Service byte (default):
Tracing route over a maximum of 20 hops
1 192.168.21.1 30 ms 10 ms 10 ms
2***
3***
To Next Page
Loading...
