1352 User Interface Commands
enable
Use the enable command in User EXEC mode to enter the Privileged EXEC
mode.
Syntax
enable
Default Configuration
The default privilege level is 15.
Command Mode
User EXEC mode
User Guidelines
If there is no authentication method defined for enable, then a level 1 user is
not allowed to execute this command.
Example
The following example shows how to enter privileged mode.
console>enable
console#
end
Use the end command to get the CLI user control back to the privileged
execution mode or user execution mode.
Syntax Description
end
Default Configuration
This command has no default configuration.
To Next Page
Loading...
