Dell PowerConnect 6224 - Page 208

208 ACL Commands
Syntax
{deny | permit} { srcmac srcmacmask | any} { dstmac dstmacmask | any |
bpdu } [{
ethertypekey | 0x0600-0xFFFF }] [ vlan eq 0-4095 ] [cos 0-7 ]
[secondary-vlan eq
0-4095 ] [secondary-cos 0-7 ] [log] [ assign-queue
queue-id ] [{mirror |redirect} interface ]
• srcmac — Valid source MAC address in format xxxx.xxxx.xxxx.
•
srcmacmask — Valid MAC address bitmask for the source MAC address in
format xxxx.xxxx.xxxx.
•
any — Packets sent to or received from any MAC address
•
dstmac — Valid destination MAC address in format xxxx.xxxx.xxxx.
•
destmacmask — Valid MAC address bitmask for the destination MAC
address in format xxxx.xxxx.xxxx.
•
bpdu — Bridge protocol data unit
•
ethertypekey — Either a keyword or valid four-digit hexadecimal number.
(Range: Supported values are appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, Netbios, novell, pppoe, rarp.)
•
0x0600-0xFFFF — Specify custom ethertype value (hexadecimal range
0x0600-0xFFFF)
•
vlan eq — VLAN number. (Range 0-4095)
•
cos — Class of service. (Range 0-7)
• log — Specifies that this rule is to be logged.
•
assign-queue — Specifies particular hardware queue for handling traffic
that matches the rule.
•
queue-id — 0-6, where n is number of user configurable queues available
for that hardware platform.
• mirror — Copies the traffic matching this rule to the specified interface.
•
redirect — Forwards traffic matching this rule to the specified physical
interface.
•
interface — Valid physical interface in unit/<port-type>port format, for
example 1/g12.