DHCP Snooping Commands 263
Default Configuration
Logging of filtered messages is disabled by default.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g1)#ip dhcp snooping log-invalid
console(config-if-1/g1)#no ip dhcp snooping log-
invalid
ip dhcp snooping trust
Use the ip dhcp snooping trust command to configure a port as trusted. Use
the “no” form of this command to configure a port as untrusted.
Syntax
ip dhcp snooping trust
no ip dhcp snooping trust
Default Configuration
Ports are untrusted by default.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
