356 IP Addressing Commands
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The ip address dhcp command allows the switch to dynamically obtain an IP
address by using the DHCP protocol.
Example
The following example acquires an IP address for the switch management
interface from DHCP.
console(config)#ip address dhcp
ip address vlan
Use the ip address vlan command in Global Configuration mode to set the
management VLAN.
Syntax
ip address vlan
vlanid
no ip address vlan
•
vlanid
— vlan identification. (Range 1–4093)
Default Configuration
The default configuration value is 1.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
