388 LACP Commands
lacp port-priority
Use the lacp port-priority command in Interface Configuration mode to
configure the priority value for physical ports. To reset to default priority
value, use the no form of this command.
Syntax
lacp port-priority
value
no lacp port-priority
•
value
— Port priority value. (Range: 1–65535)
Default Configuration
The default port priority value is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the priority value for port 1/g8 to 247.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#lacp port-priority 247
lacp system-priority
Use the lacp system-priority command in Global Configuration mode to
configure the Link Aggregation system priority. To reset to default, use the no
form of this command.
Syntax
lacp system-priority
value
no lacp system-priority
To Next Page
Loading...
