412 LLDP Commands
lldp receive
Use the lldp receive command in Interface Configuration mode to enable the
LLDP receive capability. To disable reception of LLDPDUs, use the no form
of this command.
Syntax
lldp receive
no lldp receive
Default Configuration
The default lldp receive mode is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable the LLDP receive capability.
console(config-if-1/g3)#lldp receive
lldp timers
Use the lldp timers command in Global Configuration mode to set the
timing parameters for local data transmission on ports enabled for LLDP. To
return any or all parameters to factory default, use the no form of this
command.
Syntax
lldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-
delay]
no lldp timers [interval] [hold] [reinit]
To Next Page
Loading...
