434 Port Channel Commands
channel-group
Use the channel-group command in Interface Configuration mode to
configure a port-to-port channel. To remove the channel-group configuration
from the interface, use the no form of this command.
Syntax
channel-group
port-channel-number
mode {on|auto}
no channel-group
•
port-channel-number
— Number of a valid port-channel for the current
port to join.
•
on
— Forces the port to join a channel without LACP.
•
auto
— Forces the port to join a channel with LACP.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how port 1/g5 is configured to port-channel
number 1 without LACP.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# channel-group 1 mode on
interface port-channel
Use the interface port-channel command in Global Configuration mode to
configure a port-channel type and enter port-channel configuration mode.
To Next Page
Loading...
