Dell PowerConnect 6224 - Page 466

466 QoS Commands
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the
destination layer 4 port of a packet using the "echo" port name keyword.
console(config-classmap)#match dstl4port echo
match ethertype
Use the match ethertype command in Class-Map Configuration mode to add
to the specified class definition a match condition based on the value of the
ethertype.
Syntax
match ethertype {keyword|< 0x0600-0xffff > }
• keyword — Specifies either a valid keyword or a valid hexadecimal number.
The supported keywords are
appletalk , arp, ibmsna , ipv4, ipv6 , ipx ,
mplsmcast
, mplsucast , netbios , novell , pppoe , rarp . (Range:
0x0600–0xFFFF)
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.