Spanning Tree Commands 539
1/g4 Enabled 128.4 20000 DSC Altn
No No
1/g5 Enabled 128.5 20000 DSC Altn
No No
show spanning-tree summary
Use the show spanning-tree summary command to display spanning tree
settings and parameters for the switch.
Syntax
show spanning-tree summary
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following fields are displayed:
Spanning Tree Admin
Mode
Enabled or disabled
Spanning Tree Version Version of 802.1 currently supported (IEEE 802.1s,
IEEE 802.1w, or IEEE 802.1d) based upon the mode
parameter.
BPDU Protection Mode Enabled or disabled.
BPDU Filter Mode Enabled or disabled.
BPDU Flooding Mode Enabled or disabled.
Configuration Name Identifier used to identify the configuration currently
being used.
To Next Page
Loading...
