56 Command Groups
Address Table Configures bridging address tables.
CDP Interoperability Configures Cisco Discovery Protocol (CDP).
DHCP l2 Relay Enables the Layer 2 DHCP Relay agent for an interface.
DHCP Snooping Configures DHCP snooping and whether an interface is
trusted for filtering.
Dynamic ARP Inspection Configures for rejection of invalid and malicious ARP
packets.
Ethernet Configuration Configures all port configuration options for example
ports, storm control, port speed and auto-negotiation.
GVRP Configures and displays GVRP configuration and
information.
IGMP Snooping Configures IGMP snooping and displays IGMP
configuration and IGMP information.
IGMP Snooping Querier Configures IGMP Snooping Querier and displays IGMP
Snooping Querier information.
IP Addressing Configures and manages IP addresses on the switch.
IPv6 ACL Configures and displays ACL information for IPv6.
IPv6 MLD Snooping Configures IPv6 MLD Snooping.
IPv6 MLD Snooping
Querier
Configures IPv6 Snooping Querier and displays IPv6
Snooping Querier information.
LACP Configures and displays LACP information.
Link Dependency Configures and displays link dependency information.
LLDP Configures and displays LLDP information.
Port Channel Configures and displays Port channel information.
Port Monitor Monitors activity on specific target ports.
QoS Configures and displays QoS information.
Radius Configures and displays RADIUS information.
Spanning Tree Configures and reports on Spanning Tree protocol.
Switchport Voice Configures the Auto VoIP feature.
Table 1-1. System Command Groups
(continued)
Command Group Description
To Next Page
Loading...
