658 DHCP and BOOTP Relay Commands
bootpdhcprelay cidridoptmode
Use the bootpdhcprelay cidridoptmode command in Global Configuration
mode to enable the circuit ID option and remote agent ID mode for
BootP/DHCP Relay on the system. Use the no form of the command to
disable the circuit ID option and remote agent ID mode for BootP/DHCP
Relay.
Syntax
bootpdhcprelay cidridoptmode arpshow arpw arpoptshshow arposhow
arpwshow arp arpshoshow arpw arpshow arpmshow arpode
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the circuit ID and remote agent ID options.
console(config)#bootpdhcprelay ?
cidridoptmode........... Enable/Disable Circuit Id Option and
Remote Agent Id
Mode.
maxhopcount............. Configure the maximum hop count.
minwaittime............. Configure the minimum wait time.
The range of valid values for maxhopcount is 1–16. The range of
valid values for minwaittime is 0–100 seconds.
To Next Page
Loading...
