IPv6 Routing Commands 781
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets to true the “other stateful configuration” flag in
router advertisements
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd other-config-flag
ipv6 nd prefix
Use the ipv6 nd prefix command to configure parameters associated with
prefixes that the router advertises in its router advertisements.
Syntax
ipv6 nd prefix
prefix/prefix-length
[{
valid-lifetime
| infinite} {
preferred-
lifetime
| infinite}] [no-autoconfig] [off-link]
no ipv6 nd prefix prefix/
prefix-length
•
prefix
— IPv6 prefix.
•
prefix-length
— IPv6 prefix length.
•
valid-lifetime
— Valid lifetime of the router in seconds. (Range:
0–4294967295 seconds)
• infinite — Indicates lifetime value is infinite.
To Next Page
Loading...
