790 IPv6 Routing Commands
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing
ping ipv6
Use ping ipv6 command in Privileged EXEC mode to determine whether
another computer is on the network. To use the command, configure the
switch for network (in-band) connection. The source and target devices must
have the ping utility enabled and running on top of TCP/IP. The switch can
be pinged from any IP workstation with which the switch is connected
through the default VLAN (VLAN 1), as long as there is a physical path
between the switch and the workstation. The terminal interface sends three
pings to the target station.
Syntax
ping ipv6
{
ip-address
|
hostname
} [size
size
]
•
ipv6-address
— Target IPv6 address to ping.
•
hostname
— Hostname to ping (contact). (Range: 1–158 characters)
•
size
— Size of the datagram. (Range: 48–2048 bytes)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
