Multicast Commands 835
Default Configuration
The default election priority is 1.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ip pimsm dr-priority 12
ip pimsm hello-interval
The ip pimsm hello-interval command is used to configure the PIM-SM
Hello Interval for the specified interface. Use the “no” form of this command
to set the hello interval to the default. This command deprecates the ip
pimsm query-interval command.
Syntax
ip pimsm hello-interval
interval
no ip pimsm hello-interval
•
interval
— The hello interval (Range: 0–65535 seconds).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
