848 Multicast Commands
show ip mcast mroute static
Use the show ip mcast mroute static command in Privileged EXEC mode to
display all the static routes configured in the static mcast table if it is
specified or display the static route associated with the particular
sourceipaddr
.
Syntax
show ip mcast mroute static [
sourceipaddr
]
•
sourceipaddr
— IP address of source.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the static routes configured in the static
mcast table.
console#show ip mcast mroute static
MULTICAST STATIC ROUTES
Source IP Source Mask RPF Address
Preference
--------------- --------------- --------------- -----
-----
1.1.1.1 255.255.255.0 2.2.2.2 23
To Next Page
Loading...
