Dell PowerConnect 6224 - Page 903

OSPF Commands 903
Example
The following example displays OSPF router information.
console#show ip ospf
Router ID......................................
1.1.1.1
OSPF Admin Mode................................
Enable
RFC 1583 Compatibility.........................
Enable
External LSDB Limit............................ No
Limit
Exit Overflow Interval......................... 0
Spf Delay Time................................. 5
Spf Hold Time.................................. 10
Opaque Capability..............................
Disable
AutoCost Ref BW................................ 100
Mbps
Default Passive Setting........................
Disabled
Maximum Paths.................................. 4
Source Shows source protocol/routes that are being redistributed.
Possible values are static, connected, or RIP.
Tag Shows the decimal value attached to each external route.
Subnets When this option is not configured, OSPF will only redistribute
classful prefixes.
Distribute-List Shows the access list used to filter redistributed routes.