Dell PowerConnect 6224 - Page 926

926 OSPF Commands
• neighbor-id — Identifies the neighbor’s router ID. (Range: Valid IP
address)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 10 and its neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID.............................
192.168.2.2
Hello Interval................................. 10
Dead Interval..................................
655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
Metric......................................... 0
Neighbor State................................. down
Authentication Type............................ MD5
Authentication Key.............................
"test123"
Authentication Key ID.......................... 100