Dell PowerConnect 6224 - Page 970

970 OSPFv3 Commands
External LSDB
Overflow
OSPF enters this state when the number of external LSAs
exceeds a configured limit, as described in RFC 1765.
External LSA
Count
Shows the number of external (LS type 5) link-state
advertisements in the link-state database.
External LSA
Checksum
Shows the sum of the LS checksums of external link-state
advertisements contained in the link-state database.
New LSAs
Originated
Shows the number of link-state advertisements that have been
originated.
LSAs Received Shows the number of link-state advertisements received
determined to be new instantiations.
LSA Count The number of LSAs in the link state database.
Maximum Number
of LSAs
The limit on the number of LSAs that the router can store in its
link state database.
LSA High Water
Mark
The maximum number of LSAs that have been in the link state
database since OSPF began operation.
Retransmit List
Entries
The current number of entries on all neighbors’ retransmit lists.
Maximum Number
of Retransmit
Entries
The maximum number of entries that can be on neighbors’
retransmit lists at any given time. This is the sum for all
neighbors. When OSPF receives an LSA and cannot allocate a
new retransmit list entry, the router does not acknowledge the
LSA, expecting the sender to retransmit.
Retransmit Entries
High Water Mark
The maximum number of retransmit list entries that have been
on all neighbors’ retransmit lists at one time.
NSF Support Whether graceful restart is administratively enabled. Possible
values are Support Always, Disabled, or Planned.
NSF Restart
Interval
The number of seconds a helpful neighbor allows a restarting
router to complete its graceful restart.
NSF Restart Status Whether the router is currently performing a graceful restart.
NSF Restart Age The number of seconds until a graceful restart expires. Only
non-zero when the router is in graceful restart.
NSF Restart Exit
Reason
The reason the previous graceful restart ended. Possible values
are Not attempted, In progress, Completed, Timed out,
Topology change, and Manual clear.