982 OSPFv3 Commands
•
tunnel-id
— Tunnel identifier. (Range: 0-7)
•
loopback-id
— Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the information in VLAN 11’s virtual
interface tables.
console#show ipv6 ospf interface vlan 11
IP Address..................................... Err
ifIndex........................................ 1
OSPF Admin Mode................................
Enable
OSPF Area ID...................................
0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
To Next Page
Loading...
