Dell PowerVault ML6000 - Appendix C. Frequently Asked Questions; What happens when the certificate being used to encrypt the tapes expires? Will the Encryption Key Manager read previously encrypted tapes?; Will the Encryption Key Manager require that a certificate be renamed on renewal?

PowerVault ML6000 Maintenance Guide 95
6 Loosen the two thumbscrews located at the base of the back of the module.
7 Open the module’s access door and raise the guide pin by pulling it up and turning it slightly, as if it were
a screw. Otherwise, the guide pin may scratch the front doors of the module beneath it.
8 From the front of the library, slide the entire module toward you and lift it off of the module below it.
9 Repeat these procedures for each module that you need to remove.
10 Remove and replace the cover plates, if appropriate.
1 Thumbscrews (behind doors)
CAUTION
Before removing the 5U Library Control Module’s bottom cover plate,
the robot assembly must be parked as described in P
reparing to
Remove or Replace a Module on page 70.
1