PowerVault ML6000 Maintenance Guide 105
15 Accept the default settings by pressing Apply, or make any changes to the network settings, and then
press Apply.
The progress window displays a “Success” message when complete.
16 Press Close.
The next screen lists one or more IP addresses assigned to the library.
17 Write down the IP addresses. You will need them to log in from your Web browser.
18 Click Close.
The system logs you out and you return to the login screen.
19 Open a Web browser on the host PC and enter the following in the address bar:
http://<ipaddress>/
where <ipaddress> is one of the IP addresses assigned to the library that you wrote down earlier.
A screen appears, displaying the current version of library firmware.
20 Click the Click here to upgrade your library’s firmware link.
The Tools - Update Library Firmware screen appears.
21 Click Browse to retrieve the .tgz firmware file from the location on your computer, then click Apply.
A dialog box appears, asking you to confirm if it is OK to reboot the library.
22 Click OK.
The screen displays “WORKING” in the Progress Window.
After the firmware has been transferred from the computer to the library, the login screen appears.
If you are a field engineer and are logging in using the Service Port, enable
DHCP on your laptop, and the library will automatically assign you an IP. Then
open a Web browser and enter http://10.10.10.1 in the address bar.
The installation is NOT complete at this point. Install current library
firmware, following the steps below.
Firmware Installation can take up to 1 hour to complete. DO NOT remove
power from the library during this process.
The appearance of the login screen on the Web browser does NOT mean
the firmware upgrade has been complete on the library; it is just an
indication that the firmware image has been moved to the LCB/compact
flash card. A 14U library with six tape drives installed can take up to 50
minutes to complete this process. Actual time may vary. You will not be
able to log in until the firmware upgrade is complete.
Firmware Installation can take up to 1 hour to complete. DO NOT remove
power from the library during this process.
To Next Page
Loading...
