Using the Command-Line Interface
14
ProSafe M4100 Series Managed Switches
Table 5. CLI Command Modes
Command Mode Prompt Mode Description
User EXEC
Switch>
Contains a limited set of commands to view
basic system information.
Privileged EXEC
Switch#
Allows you to issue any EXEC command, enter
the VLAN mode, or enter the Global
Configuration mode.
Global Config
Switch (Config)#
Groups general setup commands and permits
you to make modifications to the running
configuration.
VLAN Config
Switch (Vlan)#
Groups all the VLAN commands.
Interface Config Switch (Interface <unit/slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Manages the operation of an interface and
provides access to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logical connection operation.
Line Config Switch (line)# Contains commands to configure outbound
telnet settings and console interface settings.
Policy Map
Config
Switch (Config-policy-map)# Contains the QoS Policy-Map configuration
commands.
Policy Class
Config
Switch (Config-policy-class-map)# Consists of class creation, deletion, and
matching commands. The class match
commands specify Layer 2, Layer 3, and
general match criteria.
Class Map Config Switch (Config-class-map)# Contains the QoS class map configuration
commands for IPv4.
Ipv6_Class-Map
Config
Switch (Config-class-map)# Contains the QoS class map configuration
commands for IPv6.
Router OSPF
Config
Switch (Config-router)# Contains the OSPF configuration commands.
Router OSPFv3
Config
Switch (Config rtr)# Contains the OSPFv3 configuration commands.
Router RIP Config Switch (Config-router)# Contains the RIP configuration commands.
MAC Access-list
Config
Switch (Config-mac-access-list)# Allows you to create a MAC Access-List and to
enter the mode containing MAC Access-List
configuration commands.
TACACS Config Switch (Tacacs)# Contains commands to configure properties for
the TACACS servers.
DHCP Pool
Config
Switch (Config dhcp-pool)# Contains the DHCP server IP address pool
configuration commands.
To Next Page
Loading...
