NETGEAR ProSAFE M7100-24X - Page 16

Using the Command-Line Interface
16
ProSafe M4100 Series Managed Switches
Command Completion and Abbreviation
Command completion finishes spelling the command when you type enough letters of a
command to uniquely identify the command keyword. Once you have entered enough letters,
press the SPACEBAR or TAB key to complete the word.
Ipv6-Class-Map
Config
From the Global Config mode,
enter
class-map and specify the
optional keyword ipv6 to specify
the Layer 3 protocol for this class.
See class-map on page 466 for
more information.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
Router OSPF
Config
From the Global Config mode,
enter
router ospf.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
Router OSPFv3
Config
From the Global Config mode,
enter
ipv6 router ospf.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
Router RIP
Config
From the Global Config mode,
enter
router rip.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
MAC Access-list
Config
From the Global Config mode,
enter
mac access-list extended
<name>.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
TACACS Config From the Global Config mode,
enter tacacs-server host
<ip-addr>, where <ip-addr> is
the IP address of the TACACS
server on your network.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
DHCP Pool
Config
From the Global Config mode,
enter
ip dhcp pool <pool-name>.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
DHCPv6 Pool
Config
From the Global Config mode,
enter
ip dhcpv6 pool <pool-name>.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter
Ctrl-Z.
Stack Global
Config Mode
From the Global Config mode,
enter the stack command.
To exit to the Global Config mode, enter the
exit
command. To return to the Privileged EXEC
mode, enter Ctrl-Z.
ARP Access-List
Config Mode
From the Global Config mode,
enter the
arp access-list
command.
To exit to the Global Config mode, enter the
exit command. To return to the Privileged
EXEC mode, enter
Ctrl-Z.
Table 6. CLI Mode Access and Exit (Continued)
Command Mode Access Method Exit or Access Previous Mode