NETGEAR ProSAFE M7100-24X - Page 703

Log Messages
703
ProSafe Managed Switch
Table 9. RADIUS Log Messages
Component Message Cause
RADIUS
RADIUS: Invalid data length - xxx The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Failed to send the request A problem communicating with the
RADIUS server.
RADIUS
RADIUS: Failed to send all of the request A problem communicating with the
RADIUS server during transmit.
RADIUS
RADIUS: Could not get the Task Sync
semaphore!
Resource issue with RADIUS Client
service.
RADIUS
RADIUS: Buffer is too small for response
processing
RADIUS Client attempted to build a
response larger than resources allow.
RADIUS
RADIUS: Could not allocate accounting
requestInfo
Resource issue with RADIUS Client
service.
RADIUS
RADIUS: Could not allocate requestInfo Resource issue with RADIUS Client
service.
RADIUS
RADIUS: osapiSocketRecvFrom returned
error
Error while attempting to read data from the
RADIUS server.
RADIUS
RADIUS: Accounting-Response failed to
validate, id=xxx
The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: User (xxx) needs to respond for
challenge
An unexpected challenge was received for
a configured user.
RADIUS
RADIUS: Could not allocate a buffer for the
packet
Resource issue with RADIUS Client
service.
RADIUS
RADIUS: Access-Challenge failed to
validate, id=xxx
The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Failed to validate
Message-Authenticator, id=xxx
The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Access-Accpet failed to validate,
id=xxx
The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Invalid packet length – xxx The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Response is missing
Message-Authenticator, id=xxx
The RADIUS Client received an invalid
message from the server.
RADIUS
RADIUS: Server address doesn't match
configured server
RADIUS Client received a server response
from an unconfigured server.