Tektronix MSO58

Command groups
Table 2-42: Waveform Transfer commands (cont.)
Command
Description
WFMOutpre:BYT_Nr Sets or queries the data w idth for the waveform.
WFMOutpre:BYT_Or Sets or queries the byte order of waveform points.
WFMOutpre:DOMain? Returns the domain of the outgoing waveform.
WFMOutpre:ENCdg Sets or queries the type of encoding for outgoing waveforms.
WFMOutpre:NR_Pt? Returns the number of points for the waveform transmitted in response to a
CURVe? query.
WFMOutpre:PT_Fmt? Returns the point format for the waveform.
WFMOutpre:PT_Off? Returns the trigger point relative to DATA:START for the waveform.
WFMOutpre:WFId? Returns a string describing the acquisition parameters for the waveform.
WFMOutpre:XINcr?
Returns the horizontal sampling interval.
WFMOutpre:XUNit? Returns the horizontal units for the waveform.
WFMOutpre:XZEro? Returns the (sub-sample) time between the trigger sample and the occurrence
of the actual waveform trigger.
WFMOutpre:YMUlt? Returns the vertical scale factor per digitizing level for the waveform.
WFMOutpre:YOFf? Returns the vertical offset in digitizing levels for the waveform.
WFMOutpre:YUNit? Returns the vertical units for the waveform.
WFMOutpre:YZEro? Returns the vertical offset for the waveform.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-91