Tektronix MSO58 User Manual

Commands listed in alphabetical order
Arguments
LINEAR specifie
s a linear vertical scale.
LOG specifies a logarithmic vertical scale.
Examples
DISPLAY:PLOTVIEW1:YAXIS:SC ALE LINEAR sets the plot to use a linear
vertical scale.
DISPLAY:PLOTVIEW1:YAXIS:SC ALE? might return
:DISPLAY:PLOTVIEW1:YAXIS:S CALE LOG indicating a logarithmic vertical
scale is used.
DISplay:PLOTView<x>:ZOOM:XAXIS:FROM
This command sets or queries the value of the le ft edge of the specified plot.
Group
Zoom
Syntax
DISplay:PLOTView<x>:ZOOM:X AXIS:FROM <NR3>
DISplay:PLOTView<x>:ZOOM:X AXIS:FROM?
Arguments
<NR3>isstartofthezoomx-axis.
Examples
DISplay:PLOTView1:ZOOM:XAX IS:FROM 2.0 sets the start of the zoom
x-axis to 2.0 V.
DISplay:PLOTView3:ZOOM:XAX IS:FROM? might return
:DISPLAY:PLOTVIEW3:ZOOM:XA XIS:FROM 1.9844803459459
indicating the start of the zoom x-axis is 1.9845 V.
DISplay:PLOTView<x>:ZOOM:XAXIS:TO
This command sets or queries the value of the right edge of the specified plot.
Group
Zoom
Syntax
DISplay:PLOTView<x>:ZOOM:X AXIS:TO <NR3>
DISplay:PLOTView<x>:ZOOM:X AXIS:TO?
Arguments
<NR3> is the end of the zoom x-axis.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-261

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English