Tektronix MSO58 User Manual

Commands listed in alphabetical order
Syntax
WFMOutpre:NR_
Pt?
Related Commands
CURVe, DATa, DATa:STARt, DATa:STOP, SAVe:WAVEform,,
Examples
WFMOUTPRE:NR_PT? might return :WFMOUTPRE:NR_PT 5000, indicating that
there are 5000 data points to be sent.
WFMOutpre:PT_Fmt? (Query Only)
This query-only command returns the point format for the waveform specified by
the DATa:SOUrce command. The format specifies a set of equations describing
how the scale factors in the preamble are used to give meaning to the CURVe
data points.
An error is reported if the DATa:SOUrce waveform does not exist.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Fmt?
Related Commands
CURVe, DATa:SOUrce
Examples
WFMOUTPRE:PT_FMT? might return :WFMOutpre: PT_Fmt ENV, indicating that
the waveform data is a series of min-ma x pairs.
WFMOutpre:PT_Off? (Query Only)
This query-only command returns the trigger point relative to DATa:STARt for
the waveform specified by the DATa:SOUrce command.
NOTE. This returned value is the point immediately following the actual trigger.
Group
Waveform Transfer
Syntax
WFMOutpre:PT_Off?
Related Commands
DATa:SOUrce, DATa:STA Rt, WFMOutpre:XZEro?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-895

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English