Commands listed in alphabetical order
Examples
MEASUrement:M
ATH1:REFLevels:ABSolute:FALL High 1.5
sets the
reference level to 1.5 V.
MEASUrement:
MATH2:REFLevels:ABSolute:F ALLHigh?
might return
:MEASUREMENT:MATH2:REFLEVE LS:ABSOLUTE:FALLHIGH 1.00 00
indicating the reference level is 1.0 V.
MEASUremen
t:MATH<x>:REFLevels:ABSolute:FALLLow
This command sets or que ries the value used as the low reference l evel of the
falling edge when the measuement ref level method is set to absolute. The math
number is
specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLev els:ABSolute:FALLLow <NR3 >
MEASUrement:MATH<x>:REFLev els:ABSolute:FALLLow?
Arguments
<NR3> is the high reference
level, and is the zero percent level when
MEASUrement:IMMed:REFLevel :METHod is set to Absolute.
Examples
MEASUrement:MATH2:REFLevel s:ABSolute:FALLLow -1.5 sets the
reference level to -1.5 V.
MEASUrement:MATH2:REFLevel s:ABSolute:FALLLow? might return
:MEASUREMENT:MATH2:REFLEVE LS:ABSOLUTE:FALLLOW -1.00 00
indicating the reference level is -1.0 V.
MEASUrement:MATH<x>:REFLevels:ABSolute:FALLMid
This command sets or queries the value used as the mid reference level of the
falling edge when the measurement ref level method is set to absolute. The math
number is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLev els:ABSolute:FALLMid <NR3 >
MEASUrement:MATH<x>:REFLev els:ABSolute:FALLMid?
Arguments
<NR3> is the mid reference level (where 50% is equal to MID) used to calculate the
mid reference level when the measureme nt's Ref level method is set to Absolute.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-411
To Next Page
Loading...
Need help?
General
