Tektronix MSO58 User Manual

Commands listed in alphabetical order
Examples
MEASUREMENT:C
H2:REFLEVELS:PERCENT:FALLHIG H 90.0000
sets the high
reference level for the falling edge to 90%.
MEASUREMENT:
CH2:REFLEVELS:PERCENT:FALL HIGH?
might return
:MEASUREMENT:CH2:REFLEVEL S:PERCENT:FALLHIGH 90.000 0 indicating
the high reference level for the falling edge is set to 90%.
MEASUremen
t:CH<x>:REFLevels:PERCent:FALLLow
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to B ASE) used to calculate the low reference level of the falling
edge when
the source ref level method is set to percent. The channel number
is specified by x.
Group
Measurement
Syntax
MEASUrement:CH<x>:REFLeve ls:PERCent:FALLLow <NR3>
MEASUrement:CH<x>:REFLeve ls:PERCent:FALLLow?
Arguments
<NR
3>
is the percentage (where 100% is equaltoTOP)usedtocalculatethelow
reference level when the measurement Ref level method is set to Percent.
Examples
MEASUREMENT:CH2:REFLEVELS :PERCENT:FALLLOW 10.0000 sets the
reference levels for the falling edge to 10%.
MEASUREMENT:CH2:REFLEVELS :PERCENT:FALLLOW? might return
:MEASUREMENT:CH2:REFLEVEL S:PERCENT:FALLLOW 10.0000 indicating the
referencelevelsforthefallingedgeissetto10%.
MEASUrement:CH<x>:REFLevels:PERCent:FALLMid
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the mid reference level of the falling
edge when the source ref level method is s et to percent. The channel number
is specified by x.
Group
Measurement
Syntax
MEASUrement:CH<x>:REFLeve ls:PERCent:FALLMid <NR3>
MEASUrement:CH<x>:REFLeve ls:PERCent:FALLMid?
2-388 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English