To Next Page

To Previous Page

Commands listed in alphabetical order

Arguments

<NR1> is the cus

tom b it rate.

Examples

BUS:B1:RS232C:BITRATE:CUST OM 9500 sets the bit rate for the RS-232C bus

B1 to 9500 bits-per-second.

BUS:B1:RS232C:BITRATE:CUST OM? might return

:BUS:B1:RS232C:BITRATE:CUS TOM 9500, indicating that the bit rate for the

RS-232C bus B1 is set to 9500 bits-per-second.

BUS:B<x>:RS232C:DATABits

This command sets or queries the RS-232C data width for bus<x>, where the bus

number is speciﬁed by <x>.

Conditions

Requires option SR-COMP.

Group

Bus

Syntax

BUS:B<x>:RS232C:DATABits {7,8,9}

BUS:B<x>:RS232C:DATABits?

Arguments

<NR1> speciﬁes the number of bits in the RS-232C data frame.

Examples

BUS:B1:RS232C:DATABITS 8 sets the data bits to 8 for the RS-232C bus B1.

BUS:B1:RS232C:DATABITS? might return :BUS:B1:RS23 2C:DATABITS 8,

indicating that the data bits is set to 8 for the R S-232C bus B1.

BUS:B<x>:RS232C:DELIMiter

This command sets or queries the RS-232C string delimiter on bus <x>, where

the bus number is speciﬁed by <x>. This command only applies when Packet

view is turned On.

Conditions

Requires option SR-COMP.

Group

Bus

MSO54, MSO56, MSO58, MSO58LP Programmer 2-165

Tektronix MSO58 User Manual

Other manuals for Tektronix MSO58