Tektronix MSO58 - SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:IDentifier:MODe; SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:IDentifier:VALue

Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:CAN:IDentifier:MODe
This command sets or queries the CAN bus trigger identifier (address) mode to be
used when searc hing on a CAN bus signal. The search number is specified by
<x>. The sear
ch condition must be set to IDANDDATA or DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:IDentifier:MODe
{EXTENDed|STandard}
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:IDentifier:MODe?
Arguments
EXTENDed specifies the extended identifier mode.
STandard specifies the standard identifier mode.
Examples
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:IDentifier:MODe E XTEND sets
the identifier mode to extended.
SEARCH:SEARCH1:TRIGger:A: BUS:CAN:IDentifier:MODe? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:CAN:IDENTIFIER:MODE STANDARD,
indicating the identifier mode is set to standard.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:IDentifier:VALue
This command sets or queries CAN bus trigger identifier (address) value to be
used when searc hing on a CAN bus signal. The search number is specified by
<x>. The search condition must be set to IDANDDATA or DATA.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:IDentifier:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:CAN:IDentifier:VALue?
Arguments
<QString> is the identifier value.
2-648 MSO54, MSO56, MSO58, MSO58LP Programmer