Tektronix MSO58

Commands listed in alphabetical order
Syntax
POWer:POWer<x
>:REFLevels:METHod
{PERCent | ABSolute}
POWer:POWer<x>:REFLevels:M ETHod?
Examples
POWer:POWer1:REFLevels:MET Hod PERCent sets the method
to configure
reference level values as percentage for the power measurement badge 1.
POWer:POWer<x>:REFLevels:PERCent:FALLHigh
This command sets or queries the falling edge for high reference level in
percentage for the specified power measurement badge. The power measurement
badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:REFLevels:P ERCent:FALLHigh <NR1>
POWer:POWer<x>:REFLevels:P ERCent:FALLHigh?
Related Commands
POWer:POWer<x>:REFLevels:MET
Hod, POWer:POWer<x>:REFLevels:
PERCent:TYPE
Arguments
<NR1> ranges from 1 to 99.
Examples
POWer:POWer1:REFLevels:PER Cent:FALLHigh 1 sets the high refer ence
level for falling edge as 1 percentage.
POWer:POWer<x>:REFLevels:PERCent:FALLLow
This command sets or queries the falling edge for low reference level in
percentage for the specified power measurement badge. The power measurement
badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
MSO54, MSO56, MSO58, MSO58LP Programmer 2-557