Command groups
Save On comman
dGroup
Use this group of commands to program the oscilloscope to save images,
measurements, waveforms, or the instrument setup, on triggers that you select.
Table 2-36:
Save On commands
Command
Descriptio
n
SAVEON:FILE:DEST Sets or queries the location where files are saved.
SAVEON:FILE:NAME Sets or queries the file name to use when SAVEON:TRIGer is ON.
SAVEON:IMAGe:FILEFormat Sets or queries the file format to be used for saved image files.
SAVEON:IMAGe Sets or queries whether to save a screen capture when a trigger occurs.
SAVEON:TRIGger Sets or queries whether to save a file when a trigger occurs.
SAVEON:WAVEform Sets or queries whether to save a waveform when a limit test failure, mask failure,
or trigger occurs.
SAVEON:WAVEform:FILEFormat Sets or queries the file format for saving waveform.
SAVEON:WAVEform:SOURce Sets or queries the sources for saving waveforms.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-63
To Next Page
Loading...
